Touch Panel

Part	Name	Details	Notation in this manual
	START X key	Returns the printer to the front of the table. Press and hold until the printer begins moving.	[TS : START X]
	STOP key	Stops the printer when moving to a specified location.	[TS : STOP]STOP
	END X key	Moves the printer to the back of the table. Press and hold until the printer begins moving.	[TS : END X]
	FRONT key	Moves the printer to the front. The printer moves while the key is pressed and stops moving when the key is released.	[TS : FRONT]
	BACK key	Moves the printer to the back. The printer moves while the key is pressed and stops moving when the key is released.	[TS : BACK]
	X coordinates	Displays the current position in the feed direction (toward the front and back of the table) using the front of the table as the origin (zero).	[TS : X]
	Move to X coordinates	Moves the printer to the specified position in the feed direction.	[TS : X -▶]
	Z coordinates	Displays the current position in the vertical direction using the lowest point of the printer as the origin (zero).	[TS : Z]
	Move to Z coordinates	Moves the printer to the specified height.	[TS : Z -▶]
	START Z key	Moves the printer to the highest point. Press and hold until the printer begins moving.	[TS : START Z]
	RESTART key	Restarts the transporter and sets the machine origin again.	[TS : RESTART]
	AUTO Z key	Detects the print surface height of the object to be printed on. The printer will descend while the key is pressed and automatically stop when the height is detected. If the key is released before the height is detected, the printing height will be set to that height.	[TS : AUTO Z]
	UP key	Lifts the printer up. The printer moves while the key is pressed and stops moving when the key is released.	[TS : UP]
	DOWN key	Lowers the printer. The printer moves while the key is pressed and stops moving when the key is released.	[TS : DOWN]
	VACUUM/BLOW key	Suctions the object to be printed on against the table when set to VACUUM. Applies air against the object to be printed on when set to BLOW.Normally set to VACUUM. Set to BLOW if the object to be printed on is heavy and not easily moved.	[TS : VACUUM/BLOW]
	PUMP1 key	Switches the blower pump on or off.	[TS : PUMP1]
	ALARM key	Displays warning and error information.	[TS : ALARM]
	RESET key	Cancels the warning buzzer and clears the error.	[TS : RESET]
	PUMP % key	Adjusts the blower pump strength.	[TS : PUMP %]
	LIGHT key	Switches the internal lighting on or off.	[TS : LIGHT]
	SYSTEM key	Used by service technicians. Do not use this key.	[TS : SYSTEM]
	SETUP key	Used by service technicians. Do not use this key.	[TS : SETUP]