Messages
These are the main messages that appear in the Utility window to prompt correct operation. These messages are not errors, so you can close them and perform other work.
To check messages again or to carry out their corresponding actions, click 
on the home screen to display the list of messages. Click a message to display the menus and procedure required for the action. Perform operations according to the on-screen instructions.
When output, cleaning, and other operations are completed, discard the discharged fluid.
This message appears when a certain amount of discharged fluid collects in the drain pack.
The time for Daily shut down cleaning has arrived.
This message appears when it is time to perform daily shut-down cleaning.
Click and perform daily shut-down cleaning.
Perform daily shut down cleaning.
This message appears if you continue to use the machine without performing daily shut down cleaning even after The time for Daily shut down cleaning has arrived. appeared.
You will not be able to set up the media if this notification is displayed.
Click and perform daily shut-down cleaning.
The time for wiper replacement has arrived.
This message appears when it is time to replace the wiper.
Click and replace the wiper.
The time for felt wiper replacement has arrived.
This message appears when it is time to replace the felt wiper.
Click and replace the felt wiper.
Print head protection mode has activated.
This message appears when the ink in use may not be a product specified by Roland DG Corporation.
If the ink is not a product specified by Roland DG Corporation, a larger amount of ink will be consumed, and drying will be performed frequently. To obtain optimal performance, we recommend that you use ink specified by Roland DG Corporation. To purchase ink, contact your authorized dealer.
High-temperature alert
The allowable operating environment temperature has been exceeded.
Continued use may lead to nozzle drop-out or otherwise impair the performance of the printer.
- Click No to cancel printing.
Bring the installed location to a temperature at which operation is possible (20°C to 28°C [68°F to 82.4°F]), wait for the machine to cool down, and then print again.
- Click Yes to continue printing. However, there is the risk of nozzle drop-out.