Specifications
| Printing method | Piezo ink-jet method | ||
| Media | Width | 150 to 515 mm (5.91 to 20.27 in.) | |
| Thickness | Max. 1.0 mm (39.3 mil) with liner, for printing Max. 0.4 mm (15.7 mil) with liner and 0.22 mm (8.6 mil) without liner, for cutting | ||
| Roll outer diameter | Max. 150 mm (5.9 in.) | ||
| Roll weight | Max. 6 kg (13.22 lb.) | ||
| Core diameter | 76.2 mm (3 in.) or 50.8 mm (2 in.) | ||
| Printing/cutting width*1 | Max. 480 mm (18.89 in.) | ||
| Ink | Type | S-PG2 INK 220 ml or 500 ml cartridge | |
| Colors | Five colors (cyan, magenta, yellow, black, and white (2 cartridges)) | ||
| Print resolution (dpi) | Max. 1,440 dpi | ||
| Cutting speed | 10 to 150 mm/sec (0.39 to 5.90 in./sec) | ||
| Blade force*2 | 30 to 500 gf | ||
| Blade | Type | Roland CAMM-1 series blade | |
| Offset | 0.000 to 1.500 mm (0 to 0.059 in.) | ||
| Software resolution (when cutting) | 0.025 mm/step (0.98 mil/step) | ||
| Media heating system*3 | Print heater set temperature: 30°C to 35°C (86°F to 95°F) | ||
Dryer set temperature: 30°C to 38°C (86°F to 100.4°F) | |||
| Connectivity | Ethernet (100BASE-TX/1000BASE-T, automatic switching) | ||
| Power-saving function | Automatic sleep feature | ||
| Rated input | 100–240 VAC, 50/60 Hz, 2.1 A | ||
| Power consumption | During operation | Approx. 185 W | |
| Sleep mode | Approx. 32 W | ||
| Acoustic noise level | During operation | 62 dB (A) or less | |
| During standby | 60 dB (A) or less | ||
| Outer dimensions | 1,069 (W) × 787 (D) × 622 (H) mm (42.09 [W] × 30.99 [D] × 24.49 [H] in.) | ||
| Weight | 66 kg (145.51 lb.) | ||
| Environment | During operation | Temperature: 20°C to 28°C (68°F to 82.4°F) Humidity: 40% to 60% RH (no condensation) | |
| Not operating | Temperature: 5°C to 40°C (41°F to 104°F) Humidity: 20%RH to 80%RH (no condensation) | ||
| Included items | Power cord, media holders, replacement blade for separating knife, User's Manual, software (VersaWorks, Roland DG Connect), etc. | ||
*1 The length of printing or cutting is subject to the limitations of the application software.
*2
- 500 gf is the maximum instantaneous blade force.
- The blade force must be adjusted according to details such as the media thickness.
*3
- Warm-up is required after power up. This may require 5 to 20 minutes, depending on the operating environment.
- Depending on the ambient temperature and the media width, the set temperature may not be reached.