Setting the Dryer Temperature

Setting the temperature of the dryer appropriately makes the ink dry fast. An applicable application is changing the set temperature of registered media.

  • With the default settings, the temperature rises to the standby heater temperature when the power turns on. On completion of media setup, the temperature rises to the set value.

  • Depending on the usage environment, the temperature of the dryer may become higher than the set temperature, but this does not represent a problem.

  • Temperature settings are not possible when Enable Dryer accessed from List of Media Settings - Heater Temperature is off.

Procedure
  1. Set up the media.
  2. Click the following location on the home screen.

    VG3_Panel_TOP_Heater
    The Heater Temperature window appears.
  3. Check that the Enable Dryer check box is selected.

    VG3_Panel_HeaterPower_on
  4. Set the Dryer Temperature value.
    When ink drying is poor, set the temperature to a higher value. Note, however, that a temperature that is too high may degrade the media or cause it to wrinkle.
  5. Click OK to confirm your entry.
    MEMO
    • Default setting: 38°C (100.4°F)
    • You can also make this setting in the software RIP. When you have made the setting in the software RIP, the software RIP's setting is used.