Step 1: Filling with Ink

Use BY Utility to operate the machine.

In this manual, BY Utility is referred to as "Utility."

Procedure
  1. Close the front cover.
  2. Turn on the main power switch.
    BN2_MainPower2
  3. Press the sub power button.

    When the sub power button indicator changes from flashing to steady, startup is finished.

    MEMO

    After turning on the main power, wait some time before pressing the sub power button.

    Firmware initialization starts when the main power is turned on, and there will be no response when pressing the sub power button until initialization is complete.

    TurnON
  4. Start Utility from the Roland DG Connect Hub home screen.
    Click Open next to Utility.
    LaunchUtility
  5. When the Operation Guide window appears, click Next.
    FillingINK
  6. Select the type of ink being used for filling, and then click Next.
    FillingINK2

    A window appears with selections of the type of ink being used for filling. If the current selection is correct, click Next. To change the selection, click Back.

  7. Insert the ink cartridge to fill the machine with ink.
    IMPORTANT
    • When filling the machine with ink, be sure to shake any unused ink cartridges to mix the ink.

    • Before inserting the ink cartridges, shake each of them 100 times (about 40 seconds).

      The precipitation of the ingredients in the ink disables printing in normal color. So that the ink mixes well, shake the ink cartridge horizontally with a stroke length of around 5 cm (1.97 in.) from each end of the ink cartridge.


      BN-20A_Mainten_shake_cartridge

    Open the left cover and insert the ink cartridge with the same color as the ink label in the ink slot.

    Insert the ink cartridge all the way until a beep is heard.

    FillingINK4
  8. When the The ink tanks have been filled. window appears, click Next.