Normal Cleaning

MEMO If the media has already been set up, the After cleaning, perform a printing test menu appears. When this is turned on, a printing test is performed after cleaning.
Procedure
  1. Select Normal Cleaning from the head cleaning pull-down menu.
    FillingINK5
  2. Click Execute.
    Normal Cleaning is executed.
  3. Click Output.
    Printing of the test pattern starts.
  4. Check whether there is dot drop-out or dot displacement in the test pattern.
    • If there is no dot drop-out or dot displacement, click OK and proceed to Step 4: Performing Automatic Correction.
    • If the problem persists, try performing Normal Cleaning again.

      If the problem persists even after performing Normal Cleaning two or three times, perform Medium Cleaning.

    MEMO Even if nozzle drop-out does not appear to be improved by cleaning, it may be possible to ignore the effect on products if drop-out occurs in just a few locations. Try printing. If you can judge that the product is not affected, use the printer without any further cleaning.