Normal Cleaning

MEMO If the media has already been set up, the After cleaning, perform a printing test menu appears. When this is turned on, a printing test is performed after cleaning.
Procedure
  1. Select Normal Cleaning from the head cleaning item.
    FillingINK5
  2. Click Execute.
    Normal Cleaning is executed.
  3. Click Output.
    Printing of the test pattern starts.
  4. Check whether there is dot drop-out or dot displacement in the test pattern.
    • If there is no dot drop-out or dot displacement, click OK and proceed to Step 4: Performing Automatic Correction.
    • If the problem persists, try performing Normal Cleaning again.

      If the problem persists even after performing Normal Cleaning two or three times, perform Medium Cleaning.

    MEMO Even if nozzle drop-out does not appear to be improved by cleaning, it may be possible to ignore the effect on products if drop-out occurs in just a few locations. Try printing. If you can judge that the product is not affected, use the printer without any further cleaning.