2. A: Determine the positions of the media.
This section describes how to use the suction fan to prevent media skewing. When using transparent media, whose edges cannot be detected, and when Enable Detection under is set to Off, the suction fan does not activate, so media cannot be loaded with this procedure. In these cases, refer to 2. B: Determine the positions of the media (Media Edge Detection Method: off).. By default, Skewing Correction Support at Setup is set to Enable Support.
Use the following link to view a reference video for this procedure. We recommend that you view this video to understand the overall flow of work.
https://youtu.be/Os_Z7k8-3PE-
Open the front cover.
-
Move the right pinch roller () and the right media clamp () to the right end.
Press the part indicated by the arrow on the right pinch roller to move the roller and the right media clamp together.
-
Move the left pinch roller () and the left media clamp () to the left end.
Press the part indicated by the arrow on the left pinch roller to move the roller and the left media clamp together.
-
Use the following procedure to load the media.
-
Place the left media clamp and the left pinch roller.
Place the left pinch roller () within the grit pattern ().
Ensure that margin A from the left edge of the media to the left edge of the left pinch roller is at least 10 mm (0.4 in.).
-
Lower the loading lever.
-
Line up the edges of the media with the centers of the holes of the left media clamp.
- Close the front cover.