Adjustment when Cutting the Backing Paper (Perforated Cut)
When you want to cut to the backing paper in cases such as when you want to cut out the printed part, use perforated cut.
Perforated cut is a function that is included only with the BN2-30.
This function specifies the location that you want to cut by perforation in the print data and performs cutting. This is different from the perforated sheet cutting that cuts to the backing paper at fixed intervals during sheet cutting used when separating the media.
Turn the cap portion of the blade holder to adjust the amount of blade extension. Each indicator tick corresponds to 0.1 mm (3.9 mil), and adjustment for 0.5 mm (19.7 mil) can be made by rotating the cap one full turn.
The amount of blade extension () is 0 mm (0 in.) () at minimum and 2.5 mm (0.09 in.) () at maximum.
Set the amount of blade extension () so that when the cutter pierces the media (), the blade extends slightly.
Pushing the blade out too far will damage the blade and blade protector and hasten their deterioration, so exercise caution.
