Perform medium cleaning.

When performing cleaning by pressing the [CLEAN] button, it is necessary to check the cleaning operation setting. If the [CLEAN] button is pressed and cleaning is performed without checking, cleaning which is different from the cleaning you intended may be performed. Check that the setting is "Medium".

For how to check and change the setting, refer to Changing the Cleaning Operation that Is Performed When the CLEAN Button Is Pressed.

Procedure
  1. Press the [CLEAN] button.
    Medium cleaning starts.
  2. Install the paper for the printing test onto the flat table.
    Step 1: Attach the object to be printed on for the printing test.
  3. Performing a Printing Test.
    Step 2: Performing a Printing Test
  4. Check to make sure the dot drop-out or dot displacement has been corrected.
    NozzleTest_BF
    MEMO

    If the problem persists, try performing medium cleaning again.

    If problems such as dot drop-out and dot displacement persist even after you have performed medium cleaning several times, perform powerful cleaning.