1. Attach the object to be printed on.

IMPORTANT
Open and close the front cover and right cover gently. If you open and close them forcefully or release the cover when it is partly open, not only may it malfunction, but you may also be injured. When opening and closing the front cover, grasp the center of the front cover to open or close it.
CoverCaution
Procedure
  1. Open the front cover.
  2. Press [FRONT] and move the flat table forward to a position where the object to be printed on can be installed.
    MEMO

    The flat table will continue moving if you press and hold the [FRONT] button for three seconds or longer and then release it. To stop the movement, press [FRONT] again or press the [BACK] button.

  3. Press the [UP] or [DOWN] button to adjust the flat table height.
    Press the [UP] or [DOWN] button and change the value of "Height" on the display screen to the thickness of the object to be printed on.
    ThicknessMedia
  4. Install the object to be printed on the flat table.

    Place the object aligned with the flat table scale marks.

    MEMO

    With the printer initial settings, printing starts from the X-axis and Y-axis 0 scale position at the bottom right of the flat table. Align the bottom right of the object to be printed on with the X axis and Y axis scale 0 position at the bottom right of the flat table. When the printing-start location was changed, place the object to be printed on in the position of the changed coordinates.

    thickness_media2
  5. Press the [SUC] button.
    The suction fan activates to suction the object to be printed on in place.
    MEMO

    If the ends of the object to be printed on are rolled up, if the object to be printed on is thick, and in similar situations, it may not be possible to secure the media in place. For objects to be printed on whose ends are rolled up, secure them with masking tape, double-sided tape, or other means, and then use the suction function.

  6. Close the front cover.