3. Performing Normal Cleaning

You can assign the cleaning method that you frequently use to the [CLEAN] button. The default value for the cleaning operation that is performed when the [CLEAN] button is pressed is set to "Normal". Normally set the height-adjustment lever to "Normal".

For how to check and change the setting, refer to Changing the Cleaning Operation that Is Performed When the CLEAN Button Is Pressed.

Procedure
  1. Press the [CLEAN] button.
    Normal cleaning starts.
  2. Install the paper for the printing test onto the flat table.
    Step 1: Attach the object to be printed on for the printing test.
  3. Performing a Printing Test.
    Step 2: Performing a Printing Test
  4. Check to make sure the dot drop-out or dot displacement has been corrected.
    NozzleTest_BF

    If the problem persists, try performing normal cleaning again. If the printer has been used for a long period, dot drop-outs may not be fixed even after performing normal cleaning two or three times. If this is the case, clean using a different method.

    IMPORTANT

    UV ink will harden. It may adhere to the print head and solidify. If left alone, ink may clog the print heads and cause problems including printer malfunctions. Clean the head manually when printing frequently with the print head at a distance from the print surface. This is called manual cleaning. To prevent clogging of the print heads, it may be necessary to perform manual cleaning each time you print.