How to Clean the UV-LED Devices
Important notes on this procedure
-
Before performing this operation, remove any objects to be printed on.
-
To prevent the print heads from drying out, finish this procedure in 10 minutes or less.
- The cloths, alcohol, and similar items used in cleaning are not included with the product.
- Put on protective eyewear and gloves when performing this work.
| Required items | ||
|---|---|---|
 |
 |
 |
| Anhydrous ethanol or isopropyl alcohol | Cloth (that is not fluffy) | Rubber gloves |
Do not perform cleaning immediately after printing has finished. (Wait approximately 15 minutes after printing finishes.)
The area around the UV-LED device is hot and may cause burns.
When using anhydrous ethanol or isopropyl alcohol, be sure to follow the product's usage precautions.
Exercise caution regarding items such as fire, ventilation, and rashes.
Only use anhydrous ethanol or isopropyl alcohol.
Using chemicals (or similar substances) other than anhydrous ethanol or isopropyl alcohol may lead to UV-LED device damage.
Use cloth that is not fluffy to wipe off the parts. Do not use a hard material such as metal.
Using cloth that is fluffy or a hard material such as metal may lead to UV-LED device damage.