2. Securing the Print-head Carriage and Flat Table with Retainers

Attach retainers to the machine to protect it from vibration during transportation.

IMPORTANT
Open and close the front cover and right cover gently. If you open and close them forcefully or release the cover when it is partly open, not only may it malfunction, but you may also be injured. When opening and closing the front cover, grasp the center of the front cover to open or close it.
CoverCaution
Procedure
  1. Open the front cover.
  2. Open the right cover.
  3. Tighten the screw with a Phillips screwdriver, and install the retainer B.
    FixingB
  4. Close the right cover.
  5. Tighten the right cover retaining screwwith a Phillips screwdriver.
    RightCoverScrew
  6. Tighten the screw with a Phillips screwdriver, and install the retainer A.

    Press the [FRONT] or [BACK] button and move the flat table to a position where the retainer A can be installed.

    FixingA
  7. Close the front cover.
  8. Switch off the printer power.
    This completes the preparation for transport.
  9. Once the preparations are complete, move the machine with as little delay as possible.