Flat Table Height Error

This message appears when the head gap sensor comes in the contact with the object.

It is displayed when the object, fixing tape, a retainer, or similar comes in contact with the head gap sensor during non-printing operations.
It is displayed and printing stops when a height error is detected for an object during printing when the clearance setting is Stop.

It is displayed and printing stops if a height error for the object is detected during printing when the clearance setting is Readjust and the problem does not resolve even when the table was lowered to the Maximum Value (Threshold).

In all of these cases, make sure that the object is set up correctly or that the size of the object does not exceed the size that can be loaded. Set up the object correctly, or load a printable object of the size that can be loaded.