MEMOIn Utility, the window that lists the setting values of objects is called the List of Media Settings.
This window displays the setting information of the object that has been set up. This window is not displayed if the object has not been set up.
You can check and change*1 the setting values when registering the objects. To the right of Print Origin is an item to be set when changing the Origin Relative. It is not a setting for this media.
The height direction position to be printed is displayed.
Print Origin
The point (A) that will serve as the base for the printing position is displayed as the distance from the lower-right reference point (S: 0 mm [0 in.], F: 0 mm [0 in.]) (B) on the flat table.
Printing Area
The area to print that uses the print origin as the base is displayed in the distance (mm) in the W:S direction and then in the distance (mm) in the L:F direction.
Flat Table Lowering Amount
The setting values for how far down from the automatically set flat table height to print are displayed.
Object Type
Transparent or Opaque is displayed.
Printing Movement Range
The operation width of the print-head carriage when printing is displayed as either Output Data Width, Media Width, or Full Width.
MEMOMedia Width will be the width set for the printing area.
*1 You cannot change Flat Table Height and Flat Table Lowering Amount.
