Step 1: Performing a Nozzle Drop-out Test

Perform a nozzle drop-out test (print a test pattern) and confirm the test pattern before starting printing. If an error occurs, clean the print heads (normal cleaning). After that, perform the nozzle drop-out test again.
MEMO

Use the following link to view a reference video for this procedure. We recommend that you view this video to understand the overall flow of work.

https://vimeo.com/907676073/be37ed852d

Procedure
  1. Set up the nozzle drop-out test paper.
  2. On the Utility home screen, click VG3_Panel_Icon_CLEANINGCleaning.
  3. Click Output under Nozzle Drop-out Test.

    Printing of the test pattern starts.

    Utility_NozzleTest
  4. When printing is complete, open the front cover.
  5. Check whether there is dot drop-out or dot displacement in the test pattern.
    Gaps in the block pattern indicate dot drop-out, and collapsed or inclined blocks indicate dot displacement. If the test pattern is difficult to see, remove the nozzle drop-out test paper, and then change the angle to check the pattern.
    BD-8_TestPrint_Normal
  6. Remove the nozzle drop-out test paper, and then close the front cover.
  7. Click Close to return to the original screen.