Setting the Print Origin
Procedure
-
Select Origin Relative.
Set the point that will serve as the base printing position. This section describes the procedure used when using Origin Relative.MEMO
- Origin Relative: Sets the lower-right corner of the printing area as the base printing position.
- Center Relative: Sets the center of the printing area as the base printing position.
-
Click Change next to Print Origin and Printing Area.
-
Set the print origin.
Move the origin so the test pattern is printed on the nozzle drop-out test paper.MEMO You do not need to set the printing area for the nozzle drop-out test.
The upper-left corner of this area is automatically set to the maximum position.
You can also set the print origin using Numeric Input. -
Click OK.
This completes the settings for print origin and printing area. Next, we will perform a nozzle drop-out test.