Normal Cleaning

Procedure
  1. Select Normal Cleaning under Head Cleaning, and then click Execute.

    Normal cleaning will start.

    BD-8_Utility_NormalCleaning-Excute
  2. Click Output under Nozzle Drop-out Test.

    The nozzle drop-out test will start.

  3. When printing is complete, open the front cover.
  4. Check whether there is dot drop-out or dot displacement in the test pattern.

    Missing blocks indicate dot drop-out. Collapsed or inclined blocks indicate dot displacement.

    BD-8_TestPrint_Normal
    MEMO
    • If there is no dot drop-out or dot displacement, click OK.
    • If the problem persists, try performing normal cleaning again.
    • If problems such as dot drop-out and dot displacement persist even after you have performed normal cleaning two or three times, perform medium cleaning.

      Medium Cleaning