V190 Date: 2025/2/20

[change in spec.]
1. The angle of B-axis at "Front" in milling area cleaning feature has been changed to make it easier to clean the rear wall.

<NOTE>
- If you upgrade the firmware, you need to upgrade VPanel for DWX to V4.8.1 or later at the same time.

V180 Date: 2025/1/16

[bug fix] (Following problems have been fixed.)

1. The milling process may stop without any errors due to the filter cleaning signal from the dust collector (Renfert only).

<NOTE>

- If you upgrade the firmware, you need to upgrade VPanel for DWX to V4.8.1 or later at the same time.

V170 Date: 2024/12/3

[bug fix] (Following problems have been fixed.)
1. Collisions may occur under following specific conditions.

- When an adapter is clamped and the spindle is holding a milling bur or the detection pin.

- When the machine is moving to the cleaning positions of the spindle or the clamp surface and the dummy pin.

<NOTE>
- If you upgrade the firmware, you need to upgrade VPanel for DWX to V4.8.1 or later at the same time.

V160 Date: 2024/10/1

[change in spec.]

1. Improved the tool length detection to stabilize the operation.

<NOTE>

- If you upgrade the firmware, you need to upgrade VPanel for DWX to V4.8.1 or later at the same time.