Installer / Updater [ 2023-07-06, Ver.3.14 ]

Ver. 3.14 Date: 2023/7/6

[bug fix] (Following problems have been fixed.)

1. In GR2-640/540, Crop marks may not be added to long length data.

 

Ver. 3.13 Date: 2023/1/25
[change in spec.]

1. GR2-640/540 has been supported.

- Roland DG Cutter Plotter Driver must be upgraded to Ver. 1.04 or later.

- Firmware must be upgraded to Ver. 1.10 or later.

<Note>

- Existing GR2-640/540 users will need to have their firmware upgraded by a service engineer before using CutStudio.

- If you wish to upgrade the firmware version, please contact your authorized Roland DG Corporation dealer or Roland DG Corporation.

 

Ver. 3.12 Date: 2022/9/29
[change in spec.]
1. GS2-24 has been supported.

- Installer and updater are the same file.

- If the update is performed with an older version of CutStudio already installed, a confirmation screen will appear.

- Install a new instance of this application.:  

- If you specify an installation destination, it will be installed as a separate application from the existing CutStudio and existing CutStudio is kept.

-  If you do not specify an installation destination, it will be overwritten, but the previous CutStudio will remain on the Application List screen in Windows.

*  If you uninstall CutStudio, perform uninstallation of both listed CutStudio on the application list screen for complete uninstallation.
 

・Maintain or update the instance of this application selected below: 

-  CutStudio will be updated normally.

*  In either case, a new CutStudio will be launched from the Start menu.

 

Ver. 3.11 Date: 2019/4/10
[bug fix] (Following problems have been fixed.)
1. With operation systems in Korean, characters of font names in [Format] > [Font] > [Format] tab > [Font] get corrupted.


Ver. 3.10 Date: 2017/10/7
[change in spec.]
1. With GR-640/540/420, perforation force can be set now in the dialog box in [File] > [Cutting Setup].
* You need to upgrade the driver to Ver. 1.50 or later.
2. With GR-640/540/420, the icon for a perforated cut is placed at the lowest position now.


Ver. 3.00 Date: 2017/3/16
[bug fix] (Following problems have been fixed.)
1. For GS-24, the cutting area length cannot be set to 2501 mm and above.