Step 6: Perform Cutting

Procedure

Make sure the material is loaded in the machine.

1. Click .

   

2. Click OK.

   

    

3. Click OK.

   

   Cutting starts. When cutting finishes, the message shown below will be displayed.

   

4. Click OK.

   If you are using flat material, load new material before you click OK.

   • Removing the Material
   • Load the Material

   

   Cutting starts.

5. Repeat procedures 3 to 4.

   Output the set number of tiles.

    

6. Combine the output material.

   Align the margins to complete.