When to Use Tool Mode


    When it is not possible to perform alignment in Sensor Mode

    When printing and cutting without selecting the type of material

    It is not possible to use Tool Mode when using only 3 crop marks.

    Required items

     

    (1) Load the Material

    Procedure

  1. Perform preparations for cutting.
    Click the link below and complete the procedures from Step 1: Load the Material to Step 6: Set the Origin.

(2) Set Tool Mode

Procedure

  1. Press several times to display the screen shown in the figure.



  2. Press several times to display the screen shown in the figure.

     

  3. Press .


  4. Press to select TOOL MODE.

     

  5. Press .