If the material was not cut correctly (for example, if the result of the cutting test was that two shapes peeled off together), reduce the cutting speed.
When the cutting speed is fast and the material moves up and down during cutting, an excessive load will be applied to the material. In this situation as well, reduce the cutting speed.

Procedure

  1. Press [CUT CONFIG] to display the following screen.

     

  2. Press [] several times to display the following screen.

     

  3. Press [] to display the following screen.

     

  4. Press [] and [] to change the cutting speed.

     

  5. Press [ENTER] to select the setting.

     

  6. Press [MENU] to return to the original screen.