Set this setting to [ON] to feed out the material automatically during cutting.
While this setting is enabled, when cutting data is sent from the computer, cutting is performed every 1 meter after the material has automatically been fed forward (depending on the data, the material may be fed out more than 1 m, for example if the next movement point is more than 1 m back).
If material has already been fed out using the [AREA] function, the material will not be fed out automatically until the length of material that was fed out using the [AREA] function is reached, even if [PRE-FEED] is set to [ON].

* This function is only enabled when the material type has been set to [ROLL].

Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] several times to display the screen shown in the figure.

     

  3. Press [Right].

  4. Press [Down] several times to display the screen shown in the figure.

  5. Press [Right].

  6. Use [Up ] and [Down] to select [ON] or [OFF].

  7. Setting the Material Feed Speed

    When the figure shown above is displayed, press [Right] twice to display the figure shown below.

    Press [Up ] and [Down] to set the speed. 

    Setting range: 1 to 10

    Press [ENTER].

  8. Press [ENTER].

    Press [MENU] to return to the top screen.

Other Things That You Can Do