The overlap function is used when it is not possible to cut through the material in a single pass, for example, when cutting thick material.


 Factory default setting   OFF
 Setting range   OFF, 1 to 10

Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] several times to display the screen shown in the figure.

  3. Press [Right].

  4. Press [Down] several times to display the screen shown in the figure.

  5. Press [Right].

  6. Use [Up] to set the number of cuts.

    Setting range: 1 to 10

    OVERLAP 2 → Normal cut + 2 → 3 cuts are made.
  7. Press [ENTER].

    This setting remains enabled until you disable it. If you do not require it, disable it after use.

    Press [MENU] to return to the top screen.

Other Things That You Can Do