It is possible to extend the cutting area by up to 20 mm.

 Factory default setting   0.00 mm (OFF)
 Setting range   0.1 to 10.0 mm

Depending on the design to be cut, the pinch rollers may pass over the top of the cutting line.


Example: Setting 0 mm → 10 mm

When "EXTEND" Is Set after the Material Is Loaded

The value of W displayed on the panel and the actual cut width are different.
When you set the value according to the above example, the panel is displayed as shown in the figure below.

* The panel indication is 210 mm, but the actual cut width is 220 mm

When "EXTEND" Is Set before the Material Is Loaded

The value of W displayed on the panel and the actual cut width are the same.
When you set the value according to the above example, the panel is displayed as shown in the figure below.


Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] to display the screen shown in the figure.

  3. Press [Right].

     

  4. Press [Down] several times to display the screen shown in the figure.

  5. Press [Right].

  6. Use [Up ] and [Down] to set the value.

  7. Press [ENTER].

    Press [MENU] to return to the top screen.

Other Things That You Can Do