This setting lets you set the direction of the coordinate axis for cutting.
When set to [0deg] (default value), the origin is set to the lower-left corner of the material. When set to [90deg], the origin is set to the lower-right corner of the material, and the data is rotated counterclockwise by 90 degrees. Note that when [90deg] is selected, the coordinate axis changes.
The arrows in the following figures indicate the positive directions of the X and Y axes.

When Set to 0deg

When Set to 90deg

 Factory default setting   0deg
 Options   0deg or 90deg

Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] to display the screen shown in the figure.

  3. Press [Right].

     

  4. Press [Down] several times to display the screen shown in the figure.

  5. Press [Right].

  6. Use [Up ] and [Down] to set the value.

  7. Press [ENTER].

    Press [MENU] to return to the top screen.

Other Things That You Can Do