This setting lets you set the amount of offset for the tip of the blade. Set a value that matches the conditions for the blade installed.
When using the included blade or equivalent parts, cutting can be performed using the factory default setting.

(1) Offset amount
(2) Blade tip
(3) Blade centerline

 Factory default setting   0.250 mm
 Setting range   0.000 to 1.000 mm (in 0.025 mm steps)

Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] to display the screen shown in the figure.

  3. Press [Right].

     

  4. Press [Down] several times to display the screen shown in the figure.

  5. Press [Right].

  6. Use [Up ] and [Down] to set the value.

  7. Press [ENTER].

    Press [MENU] to return to the top screen.

Other Things That You Can Do