This function cuts an extra 1 mm at the start and end of each line. It is effective when you want to produce particularly sharp corners, for example when cutting thicker materials.
In most cases the over cut function should be set to [OFF]. Set it to [ON] when you want to ensure that corners are cut cleanly. However, if the over cut function is enabled when cutting small characters or complex shapes, areas of the material that are required may be cut. In such cases it should therefore be set to [OFF].

OFF ON


 Factory default setting   OFF
 Options   OFF, ON

Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] several times to display the screen shown in the figure.

  3. Press [Right].

     

  4. Press [Down] several times to display the screen shown in the figure.

     

  5. Press [Right].

     

  6. Press [Down] to select [ON].

  7. Press [ENTER].

    This setting remains enabled until you disable it. If you do not require it, disable it after use.

    Press [MENU] to return to the top screen.

Other Things That You Can Do