Printing and Cutting Sample Data
If you use the manual mode, you can perform printing and cutting without using CutStudio and Illustrator. We recommend that you get comfortable with the printing and cutting procedure by using the sample data first. In this procedure, you will create the sticker shown below.
Items Required Other than the Machine
 |
 |
 |
| Printer | Material (210 x 298 mm) | Sample data |
Printer Requirements
You must use a laser or inkjet printer with a resolution of 720 dpi or greater.
Materials That Can Be Used
Sample Data
Open the Sample.bmp file found in the CutStudio installation folder (usually located in the CutStudio folder under Program Files on the C drive).