When cutting has finished, remove the material.

Procedure

  1. Press [MENU] several times to display the screen shown below.

  2. Press [ENTER].

    The cutting carriage returns to the home position.

  3. Press [PINCH].

    The pinch rollers rise up to release the material.

  4. Remove the material by moving it through the rear of the machine.


To Remove Only the Cut Area

Procedure

  1. Press [] and [] to feed the material to the location that you want to cut.

    The material is cut off at the position shown in the figure.

      *: Groove along which the separating knife passes

  2. Hold down [SHEET CUT] for one second or longer.

    The cutting carriage moves to the left edge and then to the right edge in order to cut the material.

    After the material is cut, the cutting carriage returns to the new origin.