1. Install the detection pin.

Procedure
  1. Close all the covers.
  2. Turn on the machine.
    The machine starts the initial operations. When the status light stops flashing and remains steadily lit, initialization is complete.
  3. Clean off any milling waste from the rotary axis unit and ATC magazine.
  4. Use the included cloth for maintenance and care to wipe the clamp (), correction protrusion (), and milling bur sensor () clean.
    If any dirt is present in these locations, it may not be possible to perform the correction properly.
    IMPORTANT Also wipe the bottom of the clamp () clean.
    DWX-53DC_AutoCorrection_01
  5. Wipe the detection pin () and the top () and bottom () of the automatic correction jig clean.

    Clean the gray parts in the following figure. If any dirt is present in these locations, it may not be possible to perform the correction properly.

    IMPORTANT Also wipe the shaft of the automatic correction jig clean.
    DWX-53DC_AutoCorrection_02
  6. Load the detection pin in the ATC magazine's number 15 position.

    Insert the detection pin firmly into the ATC magazine.

    DWX-53DC_AutoCorrection_03